Q: Hi I watched a youtube video describing this hinge. Is the slot on the bottom the adjuster for the pivot bolt or do you remove that to get to the adjuster bolt?
A: Are you asking if the thrust bearing is serviceable?
Is there a follow up question that we can perhaps attempt to answer? We take pride deep in our technical expertise, as we know it separates us from our competition, so don't hesitate to ask.
Please reply to this email or contact our sales department here:
Click Here
if we can assist you by answering further questions or with entering this order and please let us know if there is anything else we can help with.
Q: No, I was looking to adjust the hinge.
A: I see. You are attempting to give yourself a bit of vertical shim or adjustment. This is not possible with the Hager 496 pivot but based on my experiences machining and hanging doors with pivot hardware, I know full well why this type of feature would be very handy.
Is there a follow up question that we can perhaps attempt to answer? We take pride deep in our technical expertise, as we know it separates us from our competition, so don't hesitate to ask.
Please reply to this email or contact our sales department here:
Click Here
if we can assist you by answering further questions or with entering this order and please let us know if there is anything else we can help with.
Q: hi Richard, If I'm using a center hung floor closer can I use an 3/4 offset intermediat pivot or not. I have a 28S Rixson. thank you
A: No - not at all. Intermediate pivots are incompatible with center hung floor closers.
Is there a follow up question that we can perhaps attempt to answer? We take deep pride in our technical expertise, as we know it separates us from our competition, so don't hesitate to ask.
Please reply to this email or contact our sales department here:
Click Here
if we can assist you by answering further questions or with entering this order and please let us know if there is anything else we can help with.